PARTS TO BE INSTALLED
rbl2013-002-006_a
1. Fender light connector
rbl2013-002-009_a
1. Cable grommet
2. Harness bracket
6. Tighten fender support screws to specification.
rbl2013-002-008_b
1. M8 x 20 hexagonal flange screws
SPECIFIED TORQUE
Fender support retaining
screws
24 N•m (18 lbf•ft)
7. Ensure harness brackets are properly posi-
tioned when torque is applied.
8. Ensure cap for wheel hub nut is properly se-
cured to steering knuckle.
rbl2014-004-050_a
TYPICAL
1. Check for harness bracket contact here
2. Wheel hub nut cap secure
9. Remove protection from suspension arms.
Windshield
1. Align windshield on windshield support.
2. Install two trims, four M5 x 16 screws, 8 wash-
ers and four nuts (from PDI kit) to secure wind-
shield.
NOTE:
There is one washer on the screw side and
one on the nut side.
rbl2013-003-016_a
1. Trims
2. Screws and washers
22 / 41
2014-3
PREDELIVERY
