Can-Am Rally 200, Operator'S Manual, Page: 81 / 140

Cooling system must be filled with
BRP premixed coolant (P/N 219 700
362) or with distilled water and an-
tifreeze solution (50% water, 50% an-
tifreeze).
Coolant Level

WARNING
Check coolant level with engine
cold. Never add coolant in cool-
ing system when engine is hot.
V06A0CY
COOLANT LEVEL
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir.
NOTE: When checking level at tem-
perature lower than 20°C (68°F), it
may be slightly lower than MIN. mark.
Add coolant up to MAX. mark if re-
quired. Use a funnel to avoid spillage.
Do not overfill.
Properly reinstall and tighten filler cap.
If the coolant is added in the coolant
reservoir, check the level in the radia-
tor too. Add coolant if necessary.

WARNING
In order to avoid potential burns,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Can-Am dealer.
To gain access to the radiator, proceed
as follows:
– Remove bolts retaining the top and
the middle of front bumper then
loosen the lower bolts.
V06L0TY
2
1
3
1. Middle bolts
2. Upper bolts
3. Lower bolts
– Remove fascia screws, 8 screws in
total.
V06L0WY
1
1. Fascia screws
_____________________
79