8
FRONT TRACK SYSTEM
INSTALLATION
1. Remove front wheels. Make sure that wheel studs
and wheel hubs are free of dirt.
2. If applicable, remove CV joint protectors.
3. Remove bolts, nuts, washers and bushings from
front stabilizing rod ends as shown in Fig. 13
Fig. 13
4. Insert bolt in front anchor brackets (
A1
) as shown in
Fig. 14
CAUTION: Make sure that the bolt is inserted in the
right direction. See Fig. 15
Fig. 15
5. Position bottom part of anchor bracket (
A1
) under
lower suspension arm. Position top part (
A2
) over
suspension arm and insert tenon in mortise cut in
bottom part. See Fig. 16
Fig. 16
6. Insert the M10x50mm bolts (
A3
) through the bottom
and secure the two parts together with the nuts (
A4
)
provided. Tighten assembly to 50 N•m [37 lb•ft] of
torque. See Fig. 17
Fig. 17
7. Secure undercarriage to front hub using the
provided 3/8-24 lug nuts (
D
). Use bolt circle
Ø156mm
.
CAUTION: If needed, take rubber protector off
of hub.
CAUTION: Follow torque specification indicated by
vehicle manufacturer when tightening wheel nuts.
