camry CR 7737, User Manual

Page: 7 / 106

7
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
2. Remove the 2 upper and 2 lower screws (B1) on the back of the head (1). Remove the heater cover - the grille (2).
3. Remove the 2 screws (B2) holding the reflector.
4. Unscrew the 2 side screws (B3) on the reflector, remove the part of the reflector that supports the heating elements at the front (B4),
and then slide the insulating hat (B5) towards the wires.
5. Squeeze the connector (B6) between your fingers, and then pull the connectors away from the heater tube. Slide the heater tube out
of the reflector.
6. Install the new heater in reverse order.
FALL PROTECTION
The device is equipped a fall safeguard. It will automatically switch off if, despite the precautionary measures you have taken, the device
falls over. In this event, unplug the device immediately.
Always check the device carefully for damage, then put it upright again. Never use a damaged device but take it to your dealer or a
recognized service point to be checked and/or repaired.
If you cannot find any damage, set the switch (3) on position 0, then plug in and switch on. Monitor the device closely for the first fifteen
minutes; if any defects occur, unplug immediately and take it to your dealer/service point to be repaired.
CLEANING
1. Always switch the device off and unplug before cleaning. Clean using a damp cloth and, if necessary, a little cleaning fluid. Never use
corrosive or abrasive cleaning agents!
2. Dust and debris may gather behind the grille (2). The grille can be removed by unscrewing the four small screws (B1) and gently
lifting off. Use a soft brush to carefully remove dust and debris. Never use a compressor as this could damage the lamps or the reflector.
Replace the grille and secure.
TECHNICAL DATA
Power: 2000W
Power supply: 220-240 ~ 50Hz
Quartz heating element 2.000 hours lifetime (model GL7734.1)
I p 24
"Caution Hot Surface" - The temperature of accessible surfaces may be higher when the equipment is in operation, which
means that the housing elements become hot during operation during operation, BE CAREFUL !!!
WARNING: In order to avoid overheating - do not cover the heater
WARNING: Do not use this equipment near swimming pools or similar water tanks