ELECTRICAL REQUIREMENTS
1
In case that it goes over
a door sill.
Don’t let the height of the
drain hose exceed 20cm
from the bottom of
washer.
2
In case of extending the
drain hose.
Don’t let the total length
exceed 3m.
3
Be careful that the end of
the drain hose is not
immersed in water.
Non-Pump Model
• Top of tub must be at least 86cm
(34inches) high and no higher than 130cm
from bottom of washer (A).
• Needs a 3cm minimum diameter
standpipe with minimum carry away
capacity of 30liters per minute.
• Top of tub must be at least 86cm
(34inches) high and no higher than 130cm
from bottom of washer (B).
Laundry tub drain system
Standpipe drain system
Pump Model
WARNING
• Electrical earth is required on this washer.
• If it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Don’t earth to a gas pipe.
• Don’t change the power supply cord plug.
• Check with a qualified electrician if you are not
sure the washing machine is properly earthed.
Recommended earthing method
Electrical shock hazard: Failure to follow these instructions could result in
death or serious injury.
A
B
3m
20Cm
5
For your personal safety , this washer must be grounded.
This washer has GROUND WIRE. To minimize electrical shock
hazard, GROUND WIRE must be connected the earthing-type
wall or ground. It is the personal responsibility and obligation of
the customer to be grounded by the qualified electrician.
20cm
GROUND
WIRE
