9
Sb500
Using the Multi-chopper
WARNING
: Make sure that the plug is not inserted!
1. Release the mixing rod (4) by turning it and pulling it out of the motor housing (3).
2. Place the multiple chopping machines on a flat, level surface and then remove the lid
(12).
3. Fill the transparent beaker (13). Do not fill the beaker to the rim, but only ¾ of the beaker
capacity.
4. Seal the bowl again with the lid; the recesses on the lower edge of the lid and on the up
-
per edge of the bowl must interlock.
5. Place the motor casing on the upper opening of the lid and fasten the multi-chopper by
turning it to the right.
6. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. Allow the
multiple chopping machine to stand on this surface during operation and until the chopping
blade is removed (14). Hold the multi-chopper firmly with a hand.
7. Press one of the buttons on the two-level control switch. You can achieve pulse operation
by pressing the button at intervals and then releasing it.
8. Remove the mains plug from the socket after use. Release the motor housing from the
multiple chopping machine by turning it and then remove it from the lid.
9. Remove the lid and pull the chopping blade (14) out carefully.
WARNING:
The chopping blade is very sharp! DANGER OF INJURY!
10. Pour the contents of the beaker into a container or plate.
11. Clean the appliance as described in “Cleaning and Storage”.
Cleaning and Maintenance
• Always pull the plug out of the socket before cleaning!
• Removable parts which have come into contact with food (utensils and bowls) can be
cleaned in soapy water.
• In order to clean the mixing rod fill the mixing bowl with water and operate the mixing rod
as described under “Using the Device”. Then dry the mixing rod thoroughly.
• Rub the outside of the motor casing with a moist towel to clean it when necessary and
then wipe it with a dry cloth.
• After cleaning, store the mixing rod in the wall mounting supplied.
ENG
