6
OPERATING INSTRUCTIONS
Emptying
• Set the valve selector knob to
“DRAIN” and the wash timer 3-5
minutes.
• The machine will now empty.
• Switch off the electricity at the power
point.
Over flow Filter
• The overflow filter is located at the
water rinse outlet of the wash tub and
should be cleaned by hand after each
use, while the lint is wet. This is im-
portant.
• To detach, place fingers in the finger
holes of the filter and pull out (Fig. 2).
• Rinse under the tape to remove lint,
etc., and push back into place.
Drain Strainer
• Remove the drain strainer from the bottom of the tub using a sharp tool such
as
§^
driver.
• Wash off the lint stuck in the strainer.
• Re-install the strainer.
Pulsator
• Should it be necessary to remove the
pulsator, say to free an.
• Obstruction, first remove the screw
securing the pulsator to the motor
shaft (Fig. 3).
• Use the tool which is supplied with the
pulsator.
• Free the obstruction and refit the
pulsator.
Ensure that the screw is securely
tightened.
Figure 2.
Figure 3.
