3
INSTALLATION
Electrical Connection
• This unit is designed to operate from an adequate supply mentioned at the
rating label sticked to the rear of it.
• In case of 3-core cord: The power cord plug must be connected to an earthed
3-pin power point within reach of the power cord.
• In case of 2 conductor power cord:Connect the grounding wire to a water faucet
etc. Make sure that the power cord is unplugged during ground work.
• Do not connect the grounding wire end to a gas tube.
• In the power cord is damaged, it should be replaced by a repair shop appointed
by the manufacturer, because special purpose tools are required.
Connection of Hoses
• Attach the drain hose to the drain outlet at the
rear of the base under and secure with the
clamp provided. Hang the “U” Shaped outlet of
the drain hose on the edge of a sink.
• Attach the water intake hose to the water inlet
located at the left-hand side of the control panel.
Press fit the other end of the hose to either a hot
or cold water tap as required (Fig. 1).
• The opening must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.
OPERATING INSTRUCTIONS
Preparing the Wash
• Sort the clothes into groups-whites, colourfast, non-colourfast, delicates,
lint free, lint producers, etc., and wash according to the laundry guide below.
• Clothes with worn patches or tears should first be mended. Empty out all
pockets and close all side fasteners. Treat bad stains prior to washing.
Prior to Washing
• Remove the plastic cover safety from the spin basket.
• Check that wash timer knob is set to position “0” and that the valve selector is
set to “WASH.RINSE”.
• Also check that overflow filter is correctly positioned.
• Encure the drain hose is in its correct position (see lnstallation).
• Inlet power cord plug into the power point and switch on.
To Wash
• Place the wash load and detergent in the wash tub. Refer to “Preparing the
Wash” and “Points to Remember”
• Set the valve selector to “WASH.RINSE”.
• Turn the water tap on fill the tub of your washing machine to the level recom-
mended in the laundry guide.
• Set the selector switch to the position recommended in the laundry guide.
WATER INTAKE HOSE
WATER INLET
Figura 1.
Caution: This unit is made of poly
propylene, use a water below 50˚C.
