CMX-FG700/FG750 Features
Back Panel
CMX-FG700/750 Set Up Instructions
1. Secure the units in a safe loca on, where they will not be subject to im
‐
pact and where there is room around the unit so nothing will interfere
with the
fi
ber op c cabling causing it to bend sharply in a ght radius in
any way which can severely a
ff
ect the signal transfer.
2. Carefully connect your source(s) to the transmi er input(s) and the re
‐
ceiver unit output(s) to your receiving device input(s) using the Cat5/5e/6
UTP RJ45 cable connectors on the transmi er and on the receiver unit.
3. CLEAN*
the
fi
ber op cal cable contacts that will be used for connec ng
the Tx and Rx units and a ach the
fi
ber cable to the
connec ons and secure, as you would secure a bayonet BNC. While
pressing lightly in on the connector, twist it in a clockwise direc on about
1/8 to 1/4 of a turn and then release. The connector should stay inserted
and have backwards spring pressure holding the bayonet in place.
4. Connect the included power supplies to the transmi er & receiver units,
and plug them both into an AC power source.
Camplex CMX
‐
FG700/CMX
‐
FG750
Page 6
Receiver
CMX
‐
FG700/750
Transmi er
&
Receiver
11
AC Power Input 2A/110
‐
240VAC 50/60Hz
11
11
Transmi er
