ASSEMBLY INSTRUCTIONS Continued:
BLACKJACK-1 Hosting Platform Preparation
There are 12 steps for this procedure:
1. Set BLACKJACK-1 unit on flat surface as shown below.
2. Please note and be aware of the two LC Single-Mode Optical Fiber cables that were pre-in-
stalled into the Neutrik OpticalCON connector housing. Note where they are protruding into
the space where the BMCC will be installed inside the BLACKJACK-1. You can see them if
you peer inside between the top and bottom of the hosting platform as shown below in the
second picture.
3. Next remove the six screws you can see from the top of the unit when the BLACKJACK-1 is
facing up. You will need a small Phillips screwdriver. Save the screws as you need them to
reinstall the top in the next few steps.