3
Important :
An overall inspection and leaks check must be carried
out at least annually and always after changing the gas
cylinder.
C - Use
SAFETY PRECAUTIONS :
It’s recommended that protective gloves be worn to
handle components which may be very hot.
Do not use the stove within 20 cm of a wall or similar
surface, or any combustible object.
Place the stove on a horizontal surface and never
move it while it is in operation. In the event of a leak
(smell of gas), close all valves.
Wait until the device has completely cooled before
handling or storing it.
After use, always close the valve on the relief valve
or gas cylinder.
Do not use containers of diameter greater than 26 cm
or less than 16 cm. Never use this appliance without
its pan supports.
The lock screws located on each side of the lid must
be locked to prevent any unintentional closure of
the lid.
Avoid twisting the flexible hose.
1) Setting up
Open the lid.
After opening the appliance, unfold the side windshields
and hook the small side catches onto the lid.
Note that the side windshields are removable and
washable.
Check that the pan support attachments are correctly
positioned in their rubber housings.
2) Lighting
-Open the gas supply (valve or lever on regulator).
-Put a flame close to the burner, then turn the knob
corresponding to the burner anticlockwise to
position( ).
-Adjust the flame to the container dimension by
positioning the knob to the defined range between
( ) and ( ).
-If you want to perfect the simmering temperature, adjust
the flame power by positioning the knob on the defined
range between ( ) and ( ).
-In the event of a strong wind orient the appliance - back
and / or side windshields facing the wind - so that the
wind does not deviate the burner flame outside the base
of the saucepan.
-When cooking is finished turn the knob corresponding
to the burner clockwise to position ( ).
Important:
Never close the appliance lid without checking
that all the burners are off, the valves closed and the
appliance has cooled down.
3) Switching off
Close the regulator or gas cylinder valve. After the flames
have gone out, close the stove valves by putting the knobs
in position ( ).
D - REMOVING OR CHANGING THE GAS
CYLINDER
-Check that the gas input is securely closed by turning
the wheel (1) - found on the regulator (2) - in a clockwise
direction (toward the « - « on the arrow) until it stops.
-Place the adjusting knobs in position ( ) by turning
them clockwise.
-Disconnect the regulator from the gas cylinder.
-Holding the regulator (2), unscrew it from the tank by
turning as shown in figure 4.
-Install the new gas cylinder.
-Connect the regulator to the new gas cylinder (check
the condition of the regulator seal, before connecting it
to the gas cylinder).
Keep young children away from the appliance, some
parts can be very hot.
Wait until the appliance has completely cooled
before any handling for storage.
After use, always close the regulator or gas
cylinder valve.
Never move the appliance when it is operating.
GB
