Campbell T107, Product Manual

Page: 32 / 102

FIGURE 6-12. 034B mounting to pipe
WARNING:
The wind vane can be easily damaged if dropped or bent. Leave the 034B wind vane in the
protective cardboard sleeve until it’s ready to be installed.
1. Remove the alignment screw at the base of the 034B-ET ( FIGURE 6-12 (p. 25)).
2. Insert the 034B into the 034B Mounting Shaft.
3. Align the hole in the shaft with that in the 034B base and replace the screw. Do not
overtighten the alignment screw. Do not remove the shoulder screw at this time.
4. Insert the mounting shaft through the U-bolt on the crossarm.
5. Adjust the mounting shaft so that the cable and connector coming out the end of the
crossarm can plug easily into the mating connector on the 034B.
6. Lightly tighten up the U-bolt clamp nuts ( FIGURE 6-11 (p. 24)).
7. Align the arrow on the alignment sticker with True South ( Determining True North and
wind sensor orientation (p. 76)). The counterweight should also point due south.
8. Make sure the sensor cable is not being pinched by the U-bolt and tighten the U-bolt to
hold the sensor firmly.
9. Plug the cable into the mating connector on the sensor. Ensure that the plug is completely
Section 6. Installation 25