K-1
Appendix K. RF400/RF410 Pass/Fail
Tests
This appendix describes a method to functionally test RF400/RF410 system
components including:
•
PC COM port
•
SC12 serial cable
•
RF400/RF410
•
RF400/RF410 Antenna
Hardware/Software Required
9
PC with one available COM port
9
Terminal Program (HyperTerminal
TM
or Procomm
TM
)
9
Two RF400/RF410s
9
Two SC12 serial cables
9
¼ wave OMNI antenna (CSI Item # 14310)
9
Two power supplies rated 12 Volts, 1 Amp
(recommend AC adapter Item # 15966 and any 12 V battery pack with
Field Power Cable Item # 14291)
The following descriptions tell how to build an RF400/RF410 loop-back test
system. Recommendations are given as to where to place the system to avoid
rf-reflections (see TESTING ¼ Wave Antenna footnote
2
in this appendix).
The basic parts of the system are:
1)
PC running a terminal program and a serial cable from PC COM port to
base RF400/RF410
2)
Base RF400/RF410
3)
Remote RF400/RF410 with RS-232 port jumper wire between TX (pin 2)
and RX (pin 3) for data loop-back.
Build the RF400/RF410 test system in the order shown:
1)
TESTING SC12 CABLE and PC COM PORT
2)
TESTING RF400/RF410s
3)
TESTING ANTENNAS
Label components of the system “known-good” as they pass the test.
TESTING SC12 CABLE and PC COM PORT
(1)
Run a terminal program such as HyperTerminal
TM
or Procomm
TM
(a) Baud rate: 9600
(b) Data, Parity, Stop Bits: 8-N-1
(c) Flow control: none
Summary of Contents for RF400
