RAWS-H Remote Automated Weather Station
5.5.3 Troubleshooting, Voice Radio Interface (part #VSP3)
If a problem with the voice radio interface (part #VSP3)
is suspected, the VSP3
may be checked by measuring the +12 V and Ground terminal on the VSP3.
Acceptable readings are +11 VDC to +14 VDC. Verify the sensor wires are
securely fastened to the VSP3 connector and the CR1000 printed circuit board
wiring panel. If problems persist, try a substitute.
5.6 CR1000 Keyboard/Display
5.6.1 General Description, CR1000 Keyboard/Display (part #CR1000KD)
The CR1000 Keyboard/Display (part #CR1000KD) shown in Figure 5.6-1 is
used to check datalogger status, display or plot sensor readings and stored
values, and to enter numeric data or change port/flag state. The CR1000KD is
powered from the CR1000 printed circuit board “CS I/O” connector via a
standard 9-pin serial cable (part #10873) that ships with the RAWS station.
Power Up Screen
Press any key for Power up Screen
Press ^ to turn on/off backlight
Press <> to adjust contrast
RAWS-H Setup Screen
Press up/down arrow to select menu item
Press Enter to see menu choices
Press up/down arrow to highlight menu choice
Press Enter to select menu choice
Press Esc to move up a menu
Press Enter to move down a menu
FIGURE 5.6-1. CR1000 Keyboard/Display
12
