Appendix D. SDI-12 Sensor Support
D-4
command SDI12 again, press <enter>, and key in the correct control port
number when prompted.
6.
To change the SDI-12 address, key in
aAb!
<enter>, where
a
is the current
address from the above step and
b
is the new address (see FIGURE
).
The OBS501 will change its address and the datalogger will respond with
the new address. To exit SDI-12 transparent mode, select the
Close
Terminal
button.
FIGURE D-2. CR1000 example of using the SDI-12 transparent mode
to change the SDI-12 address from 3 to 1. Sensor is connected to
control port 1.
