Campbell NL241, Instruction Manual

Page: 37 / 76

NL241 Wireless Network Link Interface
27
•
On the NL241 tab:
o
Set Bridge Mode to disable .
• On the RS-232 tab:
o Set Configuration to TCP Serial Server .
o
Set Baud Rate to baud rate of attached device.
o
Make note of the Serial Service Port . (The default RS-232 Serial
Service Port is 6784 . Typically, it is not necessary to change this
entry from its default.)
CS I/O Serial Server
Connect to the NL241 in DevConfig (see Section 7 , Configuring the NL241
(p. 17)
).
•
On the NL241 tab:
o
Set Bridge Mode to disable .
• On the
CS I/O
tab:
o Set Configuration to TCP Serial Server .
o Set SDC address . (Note that if multiple peripherals are connected to a
datalogger CS I/O port, each must have a unique SDC address.)
o Make note of the Serial Service Port . (The default CS I/O Serial
Service Port is 6783 . Typically, it is not necessary to change this
entry from its default.)
8.2.3.3 LoggerNet Setup
The next step is to run LoggerNet and configure it to connect to the datalogger
via the Wi-Fi port. (See example in FIGURE 8-3 below.)
1. In the LoggerNet Setup Screen , click Add Root and choose IPPort . Input
the NL241 IP address and port number. The IP address and port number
are input on the same line separated by a colon.
2. Add a PakBus® Port.
3. Add the datalogger and input the PakBus® address of the datalogger.
4. Press Apply to save the changes.
5. You can verify your settings are correct by selecting the datalogger in the
Network Map , clicking the Clock tab, and clicking Check Clocks . If
your settings are correct, you should see the current clock of your server
and datalogger.