Campbell cs215, Instruction Manual

Page: 26 / 44

CS215 Temperature and Relative Humidity Probe
Sensing part of
element NOT on
the center line
Center line of the
sensor body
FIGURE 9-2. Incorrect fit of sensor element (side view)
10. Attributions and References
AASC, 1985: The State Climatologist (1985) Publication of the American
Association of State Climatologists:
Heights and Exposure Standards for
Sensors on Automated Weather Stations , v. 9, No. 4 October, 1985.
(www.stateclimate.org/publications/state-climatologist/NOAA-NCY-
SCBOOKS-SC77097/00000029.pdf)
EPA, 2008:
Quality Assurance Handbook for Air Pollution Measurement
Systems , Vol. IV, Meteorological Measurements, Ver. 2.0, EPA-454/B-08-
002 (revised 2008). Office of Air Quality Planning and Standards,
Research Triangle Park, NC 27711.
Goff, J. A. and S. Gratch, 1946: Low-pressure properties of water from -160°
to 212°F, Trans. Amer. Soc. Heat. Vent. Eng. ,
51
, 125-164.
Lowe, P. R., 1977: An approximating polynomial for the computation of
saturation vapor pressure, J. Appl. Meteor. , 16 , 100-103.
16