Campbell CR9000X, Instruction Manual

Page: 6 / 24

Overview
OV-2
MEASUREMENTS:
Analog Output Peripheral (AO4)
CANBus Interface Peripheral (CANBUS)
CSAT3 Sonic Anemometer (CSAT3)
DSP4 Display (DSP4)
I/O Port Peripheral (CD16AC)
Interval Timer Peripheral (INT8)
Output Data to PC Card (CardOut)
Serial Input/Output Peripheral (SIO4)
Switch Closure Measurement Peripheral (SW8A)
CR9032 CPU
RS-232 CS I/O ETHERNET CARD PC-CARD
MADE IN USA
STATUS
Top of Card Faces Down
CONTROL
SDM
+12 G C1 C2 C3
FIGURE OV1-2. CR9032
CR9041 A/D and Amplifier Module
The CR9041 A/D and Amplifier Module provides signal conditioning and 16
bit, 100 kHz A/D conversions.
CR9041 A D
CR9000X
MEASUREMENT & CONTROL SYSTEM
LOGAN, UTAH
MADE IN USA
FIGURE OV1-3. CR9041
CR9011 Power Supply Module and AC Adapter
The CR9011 Power Supply Module provides regulated power to the CR9000X
from the internal battery modules. It also regulates battery charging from
power supplied by the AC adapter, a DC input, or other external sources. The
AC adapter may be used where AC power is available (100 - 240 volts) to
provide power to the CR9000X and charge its batteries.
The CR9011 has a relay that allows shutting off power under program control.
The Power Up inputs allow an external signal to awaken the CR9000X from a
powered down state (PowerOff, Section 9). When the CR9000X is in this
power off state the On/Off switch is in the on position but the internal relay is
open. The power LED is not lit. If the "<0.5 " input is switched to ground or
if the ">2" input has a voltage greater than 2 volts applied, the CR9000X will
awake, load the program in memory and run. If the "< 0.5" input continues to
be held at ground while the CR9000X is powered on and goes through its 2-5
second initialization sequence, the CR9000X will not run the program in
memory. The CR9011's 12VOUT supply is current limited to 300 mA.