Campbell CR300 series, Operator'S Manual

Page: 13 / 86

CR300-Series Datalogger
3
4.1 Configure Software
Watch the video for Sections 4.1 – 4.2: CR300 QuickStart Part 2.
To set up communications with a CR300-RF407-series
datalogger, refer to the Datalogger RF407-Series Spread
Spectrum Radio Option Communication Setup Guide
.
When LoggerNet , PC400 , or
PC200W is first run, the EZSetup
Wizard
runs automatically in a new
window. If this is not the first time
the software has been run, open the
EZSetup Wizard . Do this by clicking
the Add Datalogger button (shown
on the right).
Click Next .
Select the CR300Series in the
Datalogger Type and Name list.
Give the CR300 a name, such as a
site or project name, to identify it
within your software.
Click Next .
LoggerNet
and
PC400
only:
Select the connection type.
Click Next .
If this is the first time connecting
your PC to a CR300, click Install
USB Driver
…
to install the USB
driver.
NOTE
Select Direct Connect .