CR10X INDEX
INDEX-9
STD DEV, see Standard Deviation in Time -
[Instruction 82]
Step Loop Index - [Instruction 90]
12-5
Stop Bit
6-7
Storage
see Final Storage, Input Storage, and
Intermediate Storage
Storage and retrieval options, Data
OV-20, 4-1, 6-1
Storage Module Pointer (SPTR)
2-2
Storage Modules
4-4
Addressing with CR10X
4-2, 4-4
Commands to (
∗
9 Mode)
4-5
Current drain, Typical
14-2
File Mark
4-4
Manually initiated data output (
∗
8 Mode)
4-5
Save/load program (
∗
D Mode)
1-12
Use with Instruction 96
4-1, 4-5
Storage peripherals, External
4-1
Store Area, see Set Active Storage Area -
[Instruction 80]
Strip charts
Converting 0-360 wind direction output
to 0-540
8-7
Use with SDM-AO4
8-6
Subroutines
Entering
1-2
Label Subroutine - [Instruction 85]
12-1
Port Interrupt Subroutines
12-1
Programming Examples
8-10, 8-21
Subtract - [Instruction 35]
10-1
SW8A Switch Closure Input Module, see
SDM-SW8A
Switch 12V channel
OV-3, OV-4, 14-7
Programming example
8-23
Switch closure
Counting on Tipping Bucket
Rain Gage
8-5
Measuring
9-1
Switch Closure Input Module, see SDM-SW8A
Switching power to a device
14-7
Synchronous, Definition
A-3
Synchronous Device Communication (SDC)
6-4
System memory
OV-5, 1-7
System status (
∗
B Mode)
1-9
T
Tables, List of
LT-1
see also Program Tables
TC, see Thermocouples
TCOM
OV-11, OV-13, 1-10, 6-8, 12-7, G-3
TD (Transmitted Data)
6-6
TDR, see SDM-TDR
TELCOM
12-7, G-6
Telecommunication
5-1
Automatic setting of baud rate
5-1
Automatic time-out from
5-2
Commands
5-3
Key definitions
OV-11
Password/Security
5-4
Remote keyboard
OV-11
,
5-4
Telecommunication states
5-4
with Binary responses
C-1
Telecommunications Command
OV-11
Telecommunications (Modem) Pointer (MPTR)
2-2
Temp (107), see 107 Thermistor Probe -
[Instruction 11]
Temp, Module, see Internal Temperature -
[Instruction 17]
Temp RTD, see Temperature from Platinum
R.T.D. - [Instruction 16]
Temp TC DIFF, see Thermocouple Temperature
Measurement - [Instruction 14]
Temp TC SE, see Thermocouple Temperature
Measurement - [Instruction 13]
Temperature from Platinum R.T.D. -
[Instruction 16]
9-8
Programming examples
7-8, 7-9, 7-11, 8-13
Temperature from thermocouples, see
Thermocouple temperature
Temperature of Module, see Internal
Temperature - [Instruction 17]
Temperature range, CR10X
14-1
Terminal emulator
OV-11
TGT1 Telonics GOES - [Instruction 120]
12-10
Thermocouple Measurements
13-12
Thermocouple Temperature Measurement
Differential - [Instruction 14]
9-8
Programming example
7-4
Single-Ended Measurement -
[Instruction 13]
9-7
Technique/error analysis
13-13
Using an External Reference Junction
7-4
Three Wire Half Bridge - [Instruction 7]
9-5,
13-18, 13-19, 13-20
Programming example
7-9
Throughput rate, Definition
1-1
,
A-3
Time - [Instruction 18]
9-9
Programming example
12-4
Time
Execution time requirements for instructions
3-6
Real Time, see Record Real Time -
[Instruction 77]
Setting/displaying (
∗
5 Mode)
1-4
Standard Deviation in Time - [Instruction 82]
11-8
Storing in Final Storage
11-4
Timer - [Instruction 26]
9-14
Timer, see SDM-INT8 8 Channel Interval
Summary of Contents for CR10X
