![background image](http://html1.mh-extra.com/html/campbell/cm106bk/cm106bk_product-manual_489019030.webp)
CM106BK Tripod Kit
24
FIGURE 6-5. CMB200 components
6.4.3 Assembly
1.
Consult FIGURE
and TABLE
to determine which brackets are
needed at either end of the brace to attach it to the crossarm and tripod
mast or tower. The figure also indicates what orientation is needed when
the small bracket is used.
Each bracket has a long tab and short tab where the bolts are
attached. The brace arm must be attached to the end with the long
tab.
2.
Attach one end of the brace arm to the tripod mast or tower below the
crossarm. Leave the bolts finger-tight.
3.
Lift the free end of the brace arm to the crossarm and attach it to the
crossarm. Again, only finger-tighten the bolts.
4.
Adjust the position of the brace arm as needed.
5.
Fully tighten the two bolts directly connected to the brace arm, and then
tighten the remaining two bolts to clamp the brace arm to the crossarm and
tower or tripod mast.
NOTE
Summary of Contents for CM106BK
Page 1: ...CM106BK Tripod Kit Revision 10 19 Copyright 2011 2019 Campbell Scientific Inc ...
Page 11: ...CM106BK Tripod Kit 5 FIGURE 5 1 Tripod component dimensions ...
Page 17: ...CM106BK Tripod Kit 11 FIGURE 5 4 Leg attachment Clamp Nut ...
Page 28: ...CM106BK Tripod Kit 22 FIGURE 6 3 CM220 Right Angle Mounting Kit CM220 CM220 ...