2
BEST PRACTICES
u
For best output, maintain pressure at the tool of 90 PSI.
u
The longer your air hose the greater the pressure drop from compressor to tool.
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
u
Failure to lubricate and maintain your air tools properly will dramatically shorten
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.
u
Due to the excessive vibration created by this tool, a whip hose (aka leader hose) is
recommended. If using a whip hose, do NOT install a coupler set between the tool
and the whip hose.
SPECIFICATIONS
XT101000
Maximum PSI
90
CFM under load 100% duty
3.1 CFM @ 90 PSI
SCFM under load 100% duty
23.9 SCFM @ 90 PSI
Air Compressor Recommendation
26 gallon
Blows Per Minute (BPM)
2,600
Stroke Length
2-3/4 inch
Chisel Shank Diameter
0.401 Parker type
taper shaft
Air Inlet
1/4 inch NPT (F)
Minimum Hose Size
3/8 inch
Housing Material
Composite
Tool Weight
2.9 Lbs.
Tool Length
6-7/8 inch
Tool Height
6-3/8 inch
Tool Width
2-1/8 inch