Campbell Hausfeld TL0539, Operating Instructions Manual

Page: 4 / 56

2
GENERAL SAFETY INSTRUCTIONS (CONTINUED)
California Proposition 65
This product can expose you to chemicals including
lead, which are known to the State of California
to cause cancer and birth defects or other reproductive harm. For more
information go to www.P65Warnings.ca.gov.
You can create dust when you cut, sand, drill or
grind materials such as wood, paint, metal, concrete,
cement, or other masonry. This dust often contains chemicals known to
cause cancer, birth defects, or other reproductive harm. Wear protective
gear.
Illinois Lead Poisoning Prevention Act
CONTAINS LEAD. MAY BE HARMFUL IF EATEN OR
CHEWED. COMPLIES WITH FEDERAL STANDARDS.
Important Safety Information
Please read and save these instructions. Read carefully before attempting to
assemble, install, operate or maintain the product described. Protect yourself
and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain
instructions for future reference.
Instructions Pertaining To A Risk Of Fire, Electric Shock, Or Injury To
Persons.
This manual contains important safety, operational and maintenance
information. If you have any questions, please visit www.campbellhausfeld.
com for customer assistance.
When using tools, basic precautions should always
be followed, including the following:
General Safety
This product is a part of a high pressure system and the following safety
precautions must be followed at all times along with any other existing safety
rules.
1. Read ALL manuals included with this product carefully. Be thoroughly
familiar with the controls and the proper use of the equipment.
2. ONLY persons well acquainted with these rules of safe operation should
be allowed to use the air tool.
Do NOT exceed maximum operating pressure of the
air tool (90 PSI). The air tool COULD explode and
result in death or serious personal injury.
3. Do NOT exceed any pressure rating of any component in the system.
Maximum operating pressure of 90 PSI is measured at the tool inlet
while the tool is running. The pressure drop between the compressor
and tool needs to be compensated for at the compressor.
Release ALL pressure from the system before
attempting to install, service, relocate or perform
any maintenance.
4. Disconnect air tool from air supply when not in use and before changing
tools, attachments or performing service.
MANUAL