background image

30 Sp

Lavadoras a Presión

1. Asegúrese de que la lavadora a presión esté funcio-

nando.

2. Gire el indicador de la tapa

hacia la posición de encendido
“ON” para aplicar el jabón
(Figura 4).

3. Tire hacia atrás la boquilla

negra para asegurarse que la
lanza esté en el modo de alta
presión (Figura 5). 

4. Gire la cubierta de la boquilla

para ajustar el patrón de rocia-
do de chorro a rociado amplio
(Figura 6).

5. Antes de enjuagar, mueva el

indicador de la tapa hacia la posición
de “OFF” (apagado) para cerrar el sum-
inistro de jabón (Figura 7).

6. Proporción de agua/jabón: 12 a 1

Figura 5

Figura 6

PRESIÓN ALTA

Figura 7

Figura 4

Operación de alta presión

Para ordenar repuestos,
sírvase llamar al 1-800-330-0712 
(En los Estados Unidos,
o llame a su distribuidor local)

Sírvase proporcionar la siguiente información:

-Número de modelo
-Número de serie (si lo hubiera)
-Descripción y número del repuesto, según se

indica en la lista de repuestos.

Puede escribirnos a:

Campbell Hausfeld
Attn: Customer Service
100 Production Drive
Harrison, OH 45030

No. de

Descripción

Número del

Ctd.

Ref.

repuesto

1

Lanza de inyección

1

2

Tanque de la lanza

1

3

Anillo en O

1

4

Tubo de succión

1

5

Tapa interior

1

6

Tapa exterior

1

7

Tornillo

MJ106100AV

1

8

Anillo en O

MJ106511AV

3

9

Tubo de conexión

PM268450AV

1

10

Conj. de válv. de retención

1

11

Pesa del tubo de succión

1

12

Grapa

PM342410AV

Juegos de Repuesto

Juego de la Lanza

PM268500AV

1

Juego del tanque

PM268680SJ

1

12

11

1

2

3

4

5

6

9

10

7

8

8. Keep operation area clear of all

persons.

9. Do not overreach or stand on

unstable support. Keep good footing
and balance at all times.

10. Follow the maintenance instructions

specified in the manual.

Risk of injection 
or severe injury.

Keep clear of nozzle. Do not discharge
streams at persons. This product is to
be used only by trained operators.
Always remove lance from gun before
cleaning debris from tip.

Keep clear of nozzle. NEVER direct
high pressure spray at a person,
animal, or yourself.

Always wear safety glasses or
goggles and protective equipment
(hearing protection, gloves, rubber
boots, protective clothing) when
operating or performing
maintenance.

Never put hand or fingers over the
spray tip while operating the unit.

Never try to stop or deflect leaks
with any body part.

Always engage the trigger safety
latch in the safe position when
spraying is stopped even if only for
a few moments.

Always follow detergent
manufacturer’s label
recommendations for proper use of
detergents. Always protect eyes,
skin, and respiratory system from
detergent use. 

Do not use pres-
sure that exceeds

the operating pressure of any of the
parts (hoses, fittings, etc.) in the
pressurized system. Ensure all
equipment and accessories are rated to
withstand the maximum working
pressure of the unit.

Explosion 
hazard.

NEVER spray flammable liquids or
use pressure washer in areas
containing combustible dust,
liquids, or vapors.

Never operate this machine in a
closed building or in or near an
explosive environment.

Do not remove fuel tank cap or fill
fuel tank while engine is hot or
running (allow engine to cool two
minutes before refueling). Always
fill the tank slowly.

Never disconnect the high pressure
discharge hose from the machine

while the system is pressurized. To
depressurize machine, turn power
and water supply off, then press
the gun trigger 2-3 times.

Never permanently engage the
trigger mechanism on the gun.

Never operate the machine without
all components properly connected
to the machine (handle, gun/wand
assembly, nozzle, etc.).

Equipment
damage.

ALWAYS turn water supply “ON”
before turning pressure washer
“ON.” Running pump dry causes
serious damage.

Do not operate the pressure washer
with the inlet water screen
removed. Keep screen clear of
debris and sediment.

NEVER operate pressure washer
with broken or missing parts. Check
equipment regularly and repair or
replace worn or damaged parts
immediately.

Use only the nozzle supplied with
this machine.

Never leave the wand unattended
while the machine is running.

Never tamper with the engine
governor or attempt to alter
factory settings. Altering factory
settings could damage the unit and
will void the warranty.

Always hold gun and wand firmly
when starting and operating the
machine.

NEVER allow the unit to run with
the trigger released (off) for more
than one minute. Resulting heat
buildup will damage the pump.

NEVER store the pressure washer
outdoors or where it could freeze.
Freezing temperatures can seriously
damage the pump.

Release the trigger when changing
from high to low pressure modes.
Failure to do so could result in
damage to the nozzle.

Keep hose away 
from sharp objects.

Bursting hoses may cause injury.
Examine hoses regularly and replace if
damaged. Do not attempt to mend a
damaged hose.

3

www.chpower.com

Safety Guidelines

This manual contains information that
is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.

Danger indicates an 
imminently

hazardous situation which, if not
avoided, WILL result in death or serious
injury.

Warning indicates a 
potentially

hazardous situation which, if not
avoided, COULD result in death or
serious injury.

Caution indicates a 
potentially

hazardous situation which, if not
avoided, MAY result in minor or
moderate injury.

Notice indicates
important

information, that if not followed, may
cause damage to equipment.

NOTE

: Information that requires special

attention.

Important Safety Instructions

SAVE THESE INSTRUCTIONS

When using this product, basic
precautions should always be followed,
including the following:

1. Read all instructions before using the

product.

2. To reduce the risk of injury, close

supervision is necessary when the
product is used near children.

3. Follow all safety codes as well as the

Occupational Safety and Health Act
(OSHA).

4. Ensure safety devices are operating

properly before each use. DO NOT
remove or modify any part of the
gun or unit.

5. Know how to stop this product and

bleed pressure quickly. Be thoroughly
familiar with the controls.

6. Stay alert – watch what you are

doing.

7. Do not operate the product when

fatigued or under the influence of
alcohol or drugs.

Safety and Warning Information

Pressure Washers

Summary of Contents for PW2575

















Reviews: