5
Operating Instructions
NB006401
www.chpower.com
Operating Instructions
(Continued)
OPERATIONAL MODE - SINGLE CYCLE
Always know the
operational mode of
the tool before using. Failure to know
the operational mode could result in
death or serious personal injury.
This tool requires the
trigger to be pulled
each time a nail is
driven. The nailer
can be actuated by
depressing the WCE against the work
surface followed by pulling the trigger.
The trigger must be released to reset
the tool before another nail can be
driven.
WORK CONTACT ELEMENT (WCE)
Check the operation
of the Work Contact
Element (WCE) trip mechanism before
each use. The WCE must move freely
without binding through its entire
travel distance. The WCE spring must
return the WCE to its fully extended
position after being depressed. Do
not operate the nailer if the WCE trip
mechanism is not operating properly.
Personal injury may occur.
1. Disconnect the air
supply from the
nailer.
2. Remove all
nails from
the magazine
(see Loading/
Unloading).
3. Make sure the
trigger and work
contact element (WCE)
move freely up and
down without sticking
or binding.
4. Reconnect air
supply to the
nailer.
5. Depress the Work
Contact Element
(WCE) against the
work surface without
pulling the trigger.
The nailer
MUST NOT OPERATE
.
Do not use the tool if it operates
without pulling the trigger. Personal
injury may result.
6. Remove the nailer from
the work surface. The
Work Contact Element
(WCE) must return
to its original down
position. The nailer
MUST NOT
OPERATE
. Do not use the tool if it
operates while lifted from the work
surface. Personal injury may result.
7. Pull the trigger and depress the
work contact
element (WCE)
against the work
surface. The nailer
MUST NOT OPERATE
.
8. Depress the Work Contact Element
(WCE) against
the work surface.
Pull the trigger.
The nailer
MUST
OPERATE
.
An improperly
functioning tool
must not be used. Do not actuate the
tool unless the tool is placed firmly
against the work piece.
LOADING/UNLOADING THE NAILER
1. Always
disconnect
the tool from the
air supply before
loading
fasteners.
2. Pull pusher (B) back until the
latch (C) engages the pusher. Insert
strip of nails into top of
magazine (A).
3. Press latch (C) to release pusher.
4. Do not load with the safety or
trigger depressed.
5. Always unload all fasteners before
removing tool from service.
Unloading
is the reverse of loading,
except
always disconnect
the air
hose before unloading.
ADJUSTING THE NAIL PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so nails
are driven consistently. Do not
exceed 110 psi.
2. To drive the nail shallower, turn
the wheel (C) to right to the extent
desired.
3. To sink a nail deeper, turn the wheel
(C) to left to the extent desired.
4. Make sure trigger and
work contact element
(WCE) move freely up
and down without
binding or sticking after
each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is equipped
with an adjustable
direction exhaust
deflector. This is
intended to allow
the user to change
the direction of the exhaust. Simply
twist the deflector to any direction
desired.
1
2
1
2
A
B
C
Rotate
1
2
(C)
