![background image](http://html.mh-extra.com/html/campbell-hausfeld/chn70600/chn70600_operating-instructions-and-parts-manual_489826008.webp)
Operating Instructions and Parts Manual
8
Glossary
Become familiar with these terms before operating the unit.
ACTUATE (TOOL) —
To cause movement to the tool’s component(s) intended to
drive the fastener.
ACTUATION SYSTEM —
The use of a trigger, work contact element (WCE) and/
or other operating control, separately or in combination or sequence, to actuate
the tool.
AIR INLET —
The opening in which the compressed air supply is connected,
usually by means of a threaded fitting.
FASTENERS —
This tool uses 1 inch to 2-1/2 inch 15g 35° D-clipped head angle
finish nails.
MAGAzINE —
The part of the nailer that holds the Fasteners.
MAxIMUM AIR PRESSURE —
The maximum allowable pressure of compressed
air, as specified by the manufacture, for operating the tool.
NO-MAR / STUD FINDER TIP
— The no-mar / stud finder tip is designed
to eliminate marks caused by the wire-form Work Contact Element (WCE).
The no-mar tip may be removed and tethered to the tool if not required (See
INSTALLING AND REMOVING NO-MAR / Stud finder TIP) or when a slightly
deeper countersink is preferred. Simply slide the no-mar off the WCE and attach
to the storage post on the magazine. The tip also functions as a convenient stud
finder. To utilize the no-mar / stud finder tip, simply slide it over the tools WCE
(
see Figure 5
).
psi (POUNDS PER SqUARE INCH)
—Measurement of the pressure exerted by
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
qUICK COUPLER —
A
quick coupler is designed to work in combination with a
quick plug to quickly and easily join a pneumatic tool to an air hose (
see Figure 3
).
qUICK PLUG —
A quick plug is designed to work in combination with a quick
coupler to quickly and easily join a pneumatic tool to an air hose (
see Figure 4
).
REGULATOR —
A device used to control air pressure to an air operated tool
THREAD LOCK GLUE
— A locking glue that is applied to the screw threads
before installing. Prevents the screws from working loose during tool operation.
Figure 3 - Quick Coupler
Figure 4 - Quick Plug
Figure 5 - No-mar / stud finder tip
www.chpower.com
CHN70600