FT-141 Chatsworth Fountain
Revised July 21, 2017
Assemble your fountain on a level surface capable of holding a minimum of 119 pounds with
an approximate 9 square inch footprint.
FT-141B (97 lbs)
21” W x 28.5” H
FT-141A (5 lbs)
5.5” W x 2.75” H
1.
Position the basin (FT-141B) where the fountain
is to be installed, ensuring that it is level.
2.
Assemble the pump kit
a.
Using a hose clamp, attach the 1/2" non-
kink tubing to the pump outlet.
b.
Place the stopper around the pump cord
approximately 6 inches from the pump.
3.
Feed the pump cord through the hole in the
basin (FT-141B) and out of the channel.
4.
FIRMLY press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver
or hammer works best to press the stopper
in place.
5.
Coil the pump cord in the pump house and push
the pump down as far into the pump house as
possible.
6.
Secure the loose end of the 1/2" non-kink tubing
to the water feature (FT-141A) with a hose
clamp.
7.
Place the water feature (FT-141A) into the basin
(FT-141B) ensuring that it is level.
a.
Turn the feature to coil the tubing as you
lower it into position.
8.
Fill the fountain with water.
