FT-114 Vicobello Fountain
Three people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 1052 pounds with an approximate 2.75 square foot footprint.
FT-114I (140 lbs)
20”L x 20”W x 6”H
FT-114H (150 lbs)
15.5”L x 15.5”W x 18”H
FT-114G (327 lbs)
47”W x 6.5”H
FT-114E (60 lbs)
12.5”W x 16.25”H
FT-114D (116 lbs)
32”W x 9.5”H
FT-114C (39 lbs)
13”W x 14.5”H
FT-114B (27 lbs)
18.25”W x 5.25”H
FT-114A (11 lbs)
5.5”W x 11”H
FT-114F (3 lbs)
5.25”L x 2”W x 4”H
1.
Place the base (FT-114I) into position where the fountain will be installed, ensuring that it is level.
a.
Note: Check that all components are leveled as the fountain is assembled.
2.
Center the large pedestal (FT-114H) over the base.
3.
Assemble the fountain plumbing
a.
Attach the 20” length of non-kink tubing to the pump outlet.
b.
Place the stopper around the pump cord approximately 6” from the pump.
4.
Center the large bowl (FT-114G) over the large pedestal (FT-114H) making sure the holes line up.
5.
Feed the pump cord all the way through the holes in the bowl (FT-114F) and pedestal (FT-114H) then
out of the access door in the base (FT-114I).
6.
FIRMLY
press the stopper into the hole evenly.
a.
Note: Using the handle of a screwdriver or hammer works best to press the stopper in place.
7.
Position the medium pedestal (FT-114E) over the pump in the large bowl (FT-114G).
8.
Feed the non-kink tubing connected to the pump through the top of the medium pedestal (FT-114E).
9.
Using a hose clamp, secure the loose end of the 20” length of non-kink tubing to the pipe protruding
from the bottom of the medium bowl (FT-114D).
10.
Center the medium bowl (FT-114D) over the medium pedestal (FT-114E).
11.
Connect the 15” length of non-kink tubing to the pipe protruding from inside the medium bowl (FT-
114D) with a hose clamp.
12.
Position the small pedestal (FT-114C) over the center of the medium bowl (FT-114D).
13.
Feed the non-kink tubing through the hole in the small pedestal (FT-114C).
14.
Using a hose clamp, secure the loose end of the non-kink tubing to the pipe protruding from the
bottom of the small bowl (FT-114B).
15.
Center the small bowl (FT-114B) over the small pedestal (FT-114C).
16.
Fit the finial (FT-114A) into the small bowl (FT-114B) by feeding the protruding copper pipe from the
bowl into the hole in the bottom of the finial.
17.
Place the pump cover door (FT-114F) into the medium pedestal (FT-114E).
18.
Fill the fountain with water.
Revised April 23, 2018
