FT-357 Salinas Pebble Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 195 lbs with
an approximate 2 sq. ft. footprint (actual dimensions 17.5" Diam.).
Step 1 -
Position the basin (FT-357B) where the fountain is to be installed, ensuring that it is level.
Step 2
- Assemble the pump kit:
2a
- Using a hose clamp, attach the 1/2" non-kink tubing to the pump outlet.
2b
- Place the stopper around the pump cord approximately 6 inches from the pump.
Step 3
- Feed the pump cord through the hole in the basin (FT-357B) and out of the channel.
Step 4
- FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the
stopper in place.
Step 5
- Insert the CPVC end of the tubing assembly into the coupling at the bottom of the water
feature (FT-357A).
Step 6
- Place the water feature (FT-357A) into the basin (FT-357B) ensuring that it is level.
6a
- Turn the feature and coil the tubing as you lower it into position.
Step 7
- Fill the fountain with water.
Step 8
- Spread the pebbles over the water feature (FT-357A).
FT-357B (80 lbs)
18"W x 12"H
Fountain Set-Up:
Assembly & Installation -
A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help:
Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation:
Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop:
To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet:
Use only a GFCI outlet when running a fountain.
FT-357A (24 lbs)
15.75"W x 2.75"H
