FT-214 Portwenn Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 325 lbs with an
approximate 1 sq. ft. footprint (actual dimensions 14" x 14").
Step 1 - Position the basin (FT-214B) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attached the 1/2" non-kink tubing to the pump outlet.
2b - Place the stopper around the pump cord approximately 6" from the pump.
Step 3 - Feed the pump cord through the hole in the basin (FT-214B) and out of the channel.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper in
place.
Step 5 - Coil the pump cord in the pump house and push the pump down as far into the pump
house as possible.
FT-214B (268 lbs)
26.5"L x 26.5"W x 36.75"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 6 - Holding the water feature (FT-214A) over the basin (FT-214B), insert the 1/2" CPVC
portion of the tubinf assembly into the coupling protruding from the bottom.
Step 7 - Place the water feature (FT-214A) onto the basin (FT-214B) ensuring that it is level.
7a - Turn the feature and coil the tubing as you lower it into position.
Step 8 - Fill the fountain with water.
FT-214A (22 lbs)
13.75"L x 13.75"W x 5.75"H
