FT-30 Palazzo Urn Fountain
Assembly Instructions
Professional installation is recommended for this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 1,135 lbs with an
approximate 14 sq. ft. footprint (actual dimensions 45" x 45").
Step 1 - Place the basin (FT-29C/30D) into position where the fountain will be installed, ensuring
that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, connect the preassembled tubing (diagram right) to the pump by
sliding the 12" length of non-kink tubing over the pump outlet.
2B - Place the stopper around the pump cord approximately 8 inches from the pump.
Step 3 - Feed the pump cord through the hole in the basin (FT-29C/30D) and the channel.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper in
place.
FT-29C/30D (579 lbs)
45"L x 045"W x 011"H
Fountain Set-Up:
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Place the pump cover (FT-29B/30C) over the pump. Ensure it is placed properly and
leveled.
BOTTOM OF COLUMN (FT-30B)
Step 6 - Secure the 2 open ended 6" pieces of non-kink tubing to the 2 pipes protruding from the
bottom of the column (FT-30B) by using hose clamps provided.
Step 7 - Center the column (FT-30B) on top of the pump cover (FT-29B/30C).
INSIDE OF COLUMN (FT-30B)
Step 8 - Use a hose clamp to attach the 30" length of non-kink tubing to one of the two pipes
protruding on the inside of the column (FT-30B).
FT-29B/30C (52 lbs)
12"L x 12"W x 8"H
FT-30B (115 lbs)
12"L x 12"W x 16.5"H
