FT-67 Anfora Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 867 lbs with an
approximate 11.5 sq. ft. footprint (actual dimensions 50" x 32.5").
Step 1 - Place the basin (FT-67C) into position where the fountain will be installed, ensuring that it
is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the 1/2" non-kink end of the tubing assembly to the pump
outlet.
2b - Place the stopper around the pump cord approximately 6" from the pump.
Step 3 - Feed the pump cord through the hole in the basin (FT-67B) and out the channel.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
FT-67C (376 lbs)
51"L x 33.5"W x 9"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Place the pump cover (FT-67B) over the pump.
Step 6 - Carefully position the urn (FT-67A) over the pump cover (FT-67B).
Step 7 - Insert the CPVC end of the tubing assembly into the CPVC coupling protruding from the
bottom of the urn.
Step 8 - Center the urn (FT-67A) over the pump cover (FT-67B).
Step 9 - Insert the 21" copper pipe into the CPVC fitting inside the urn (FT-67A).
Step 10 - Fill the fountain with water.
FT-67B (30 lbs)
17.5"L x 13.5"W x 5"H
FT-67A (180 lbs)
31"L x 18.5"W x 22.5"H
