Revised July 13, 2016
ASSEMBLY INSTRUCTIONS
1. Make sure you are assembling your fountain on a level surface capable of holding
a minimum of 435 pounds with approximately a 3 square foot footprint.
2. Position the basin (FT-285C) where the fountain is to be installed, ensuring that it
is level.
3. Feed the pump cord through the hole in the bottom of the base, leaving enough
cord to pull the pump out of the pump cover.
4. Position the base (FT-286E) on top of its respective basin.
5. To ensure a level installation, bring the pump cord out through the channel in the
bottom of the basin.
6. See enclosed stopper assembly instructions and complete before
continuing.
7. To ensure a proper installation, make sure all components are centered and level
before proceeding onto the next component.
8. Place the pump inside the base (FT-286E).
9. Place the pump cover (FT-287C) over the pump.
10. Place the water feature (FT-287A) on top of the pump cover
11.
Connect the ½” end of the tubing assembly to the pipe protruding down from the
bottom of the water feature (FT-287A).
12. Place the pump cover door (FT-287D) in the pump access opening of the pump
cover.
13. Place the spiller stopper (FT-287B) inside the top of the water feature (FT-287A).
14. Fill the base with approximately
20
gallons of water.
a. NOTE: Do not run fountain without sufficient water. If the pump is allowed to
run dry, it can damage the pump.
FT- 287 & 288 Falling water 3 & 4 Fountain
(6 pieces)
