FT-129 Portico Wall Fountain
Revised December 4, 2017
Make sure you are assembling your fountain on a wall and using a hanging method
that will sufficiently hold a minimum of 100 pounds.
FT-129A (89 lbs)
16”L x 11”W x 26.5H
1.
Assemble the pump kit
a.
NOTE: All pumps come with 1
adapter already inserted into the
pump and 2 adapters secured to
the power cord.
i.
This fountain uses the
largest adapter provided.
b.
Using a hose clamp, attach the 1/2”
non-kink tubing to the pump outlet.
c.
Place the stopper around the pump
cord approximately 4” from the
pump.
2.
Feed the pump cord through the hole in
the basin of the water feature (FT-129A).
3.
FIRMLY
press the stopper into the hole
evenly.
a.
Note: Using the handle of a
screwdriver or hammer works best
to press the stopper in place.
4.
Fit the clear end of the tubing assembly
over the pipe protruding in the bottom of
the basin.
5.
Hang the fountain.
6.
Fill the basin with water.
Hook Placement:
Position of back hooks:
There are 3 hooks positioned on the back. The two at the top are shaped like an upside down letter U, and are 5” from
top and 3.75” from sides. The one at the bottom is placed like the letter U. This one is meant to keep the back of the
fountain from sitting directly against the wall.
Please note these are best approximation as they are placed in mold by hand as consistently as possible.
