FT-306 Del Rey Fountain
Assembly Instructions
Three people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 900 lbs with an
approximate 3 sq. ft. footprint (actual dimensions 21.5" Diam.).
Step 1 - Position the basin (FT-306F) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the fountain plumbing:
2a - Connect the preassembled tubing to the pump by sliding the 3/4" clear tubing over
the pump outlet.
2b - Place the stopper around the pump cord approximately 8 inches from the pump.
Step 3 - Feed the pump cord all the way through the hole in the basin and run the cord through
the channel in the bottom to ensure the fountain will be level.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper in
place.
FT-306F (390 lbs)
48"W x 16.5"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Place the pump cover (FT-306D) over the pump. Ensure it is centered and leveled.
Step 6 - Position the small bowl (FT-306C) over the pump cover (FT-306D).
Step 7 - Using a hose clamp, secure the loose end of the non-kink tubing to the pipe protruding
from the bottom of the small bowl (FT-306C).
Step 8 - Center the small bowl (FT-306C) on top of the pump cover (FT-306D).
Step 9 - Using the silicone provided, secure the copper spillers to the four lips of the small bowl
(FT-306C).
FT-306D (57 lbs)
12"W x 13"H
FT-306C (103 lbs)
29"W x 10.75"H
