FT-309 Closerie Wall Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 350 lbs with an
approximate 2.75 sq. ft. footprint (actual dimensions 23.25" x 16.5").
Step 1 - Position the basin (FT-309A) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump and tubing:
2a - Using a hose clamp, attach the 1/2" non-kink tubing to the pump outlet.
2b - Place the stopper around the pump cord approcimately 8" from the pump.
Step 3 - Feed the pump cord through the hole in the back of the basin (FT-309A).
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
into place.
Step 5 - Insert the CPVC pipe end of the pre-assembled tubing into the CPVC coupling in the
center-back of the basin.
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 6 - Place the pump cover (FT-309B) over the pump.
Step 7 - Fill the fountain with water.
FT-309A (270 lbs)
25.25"L x 17.5"W x 40.5"H
FT-309B (14 lbs)
20"L x 12"W x 1"H
