Campania International Artifact M Series Assembly Instructions Download Page 3

Page: 3 / 4

FT-190 M-Series Artifact Fountain

Assembly Instructions

Step 6 - Fill the basin enough to cover the pump completely with water to check for leaking.

6a - If leaking occurs…

- Remove the stopper and repeat step 5 again.

- Use some of the excess putty to seal the cord around the top of the stopper.

See image “D”.

- Let the fountain dry completely, then use 100% clear silicone to seal around the

pump cord and perimeter of the stopper. Silicone must set for 24 hours before
adding water.

Step 7 - Place the pump house (FT-190B) over the pump and centered inside of the basin

(FT-190C).

Step 8 - Holding the water feature (FT-190A) over the basin (FT-190B), insert the CPVC end of the

tubing into the coupling protruding from the bottom.

Step 9 - Center the water feature (FT-190A) into basin (FT-190B).

Step 10 - Connect the pump cord to the transformer.

FT-190B (4 lbs)

6"L x 6"W x 3.5"H

FT-190A (8 lbs)

12"L x 12"W x 1.5"H

Summary of Contents for Artifact M Series

Page 1: ...th Tools Required Bubble Level Screwdriver Scissors Pump Kit Parts List Image Component Quantity PK120 LV pump with transformer 1 7 Stopper 1 2 5 length of PermaGum Putty 1 8 length of 1 2 black non k...

Page 2: ...ome components seem off rotate components or use wedges to level them Step 3 Create a Drip Loop To prevent water from dripping down the cord and damaging the electrical socket create a drip loop by al...

Page 3: ...100 clear silicone to seal around the pump cord and perimeter of the stopper Silicone must set for 24 hours before adding water D Step 7 Place the pump house FT 190B over the pump and centered inside...

Page 4: ...s completely seated in the fountain You can also use 100 pure clear silicone to ensure a proper seal is achieved Step 4 Cracking Your fountain may be cracked from improper winter care see Winter Care...