Fountain Components
Image
Item Description
Component
Item #
Quantity
Zen Too
Fountain Water
Feature
FT-194A
1
Andra Fountain
Base
FT-216B
1
FT-216 Andra Fountain
Assembly Instructions
rev 3/30/2020
Fountain Information:
• This fountain holds approximately 1 gallon of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• No refi ll device or submersible lights are suggested for this fountain
Pump Information:
OEMPF140 - 140 GPH Pump 6 FT cord length
Tools Required:
Bubble Level
Screwdriver
Pump Kit Parts List
Image
Component
Quantity
PK140 Pump
(use only large adapter)
1
#7 Stopper
1
Approx. 6" length of 1/2" black
non-kink tubing
1
Approx. 2" length of 5/8" clear vinyl
tubing
1
Approx. 2" length of 1/2" CPVC pipe
1
Hose Clamps
1
Fountain Set-Up:
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Proudly
MADE IN USA
