FT-216 Andra Fountain
Assembly Instructions
Assemble your fountain on a level surface capable of holding a minimum of 100 lbs with an
approximate 1/3 sq. ft. footprint (actual dimensions 7" x 7").
Step 1 - Position the basin (FT-216B) where the fountain is to be installed, ensuring that it is level.
Step 2 - Assemble the pump kit:
2a - Using a hose clamp, attach the 1/2" non-kink tubing to the pump outlet.
2b - Place the stopper around the pump cord approximately 6 inches from the pump.
Step 3 - Feed the pump cord through the hole in the basin (FT-216B) and out of the channel.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
Step 5 - Coil the pump cord in the pump house.
FT-216B (78 lbs)
19.5"L x 19.5"W x 20.25"H
Step 6 - Insert the CPVC end of the tubing assembly into the coupling at the bottom of the water
feature (FT-194A).
Step 7 - Place the water feature (FT-194A) into the basin (FT-216B) ensuring that it is level.
7a - Turn the feature and coil the tubing as you lower it into position.
Step 8 - Fill the fountain with water.
FT-194A (10 lbs)
12.25"L x 12.25"W x 2.25"H
