17 - 56
2 - SAFETY PRECAUTIONS
2)
VIBRATIONS LEVEL
Average weighted hand-transmitted vibration value, in frequency, the user is ex-posed to measured in compliance
with EN ISO 5349/1-2:
1.5 m fixed extension rod, Rotary line spool version
a
heq
= 4.38 m/s
2
1.5 m fixed extension rod, Round blade version
a
heq
= 4.38 m/s
2
1.3 ÷ 1.9 m telescopic extension rod, Rotary line spool version
a
heq
= 5.05 m/s
2
1.3 ÷ 1.9 m telescopic extension rod, Round blade version
a
heq
= 6.54 m/s
2
The resulting values, according to the auxiliary tools which have been used, have turned out to be high, since they
overcome the reference limit of 2.5 m/s
2
.
The following obligations have to be fulfilled:
•
The operator shall undergo a periodic check up.
•
The operator shall be informed about the vibrations risks.
•
The tool can be used continuously no more than 6 hours per day.
2.1.2 General precautions
2.1.2.1 Clothing and accessories
WARNING!
Always use adequate clothing and safety accessories as called for the job. Use strong boots and trousers, helmet, noise-
proof ear-cover, protective glasses (according to the ANSI Z87.1 standard) and safety gloves. Wear tight, but comfortable
clothing (Drawings A and C).
2.1.2.2 General precautions
WARNING!
•
Never allow other people to use this tool without prior reading and well understanding these instructions.
•
Never allow children to use or play with the tool.
•
Never allow bystanders or animals to stay in the danger area, i.e. about 15 m all around the tool (Fig. B).
•
Never use the equipment in places where it may contact electrical cables and high voltage power lines.
•
Always work in a stable and safe position.
•
Do not operate, service or move the tool if you are under the influence of alcohol, medicines or drugs which could
impair your alertness or co-ordination.
•
Never use the tool without the reel or disc protection.
2.2 Tool operating precautions
•
Make sure that the maximum air pressure setting in the compressor is 1000 kPa (10 bar). Higher pressure values could
cause excessive wear in the tools.
•
When the tool is connected to the compressed air supply, but it is not being used, make sure that the safety catch on the
handle is automatically engaged.
•
The user shall be held responsible for any accidents or dangerous situations affecting other people or their property.
•
Always hold the tool with both hands on the handle and make sure you are in a steady and safe work position.
•
Tools and machines shall be strictly used for the purposes described in par. ‘Product Description’. Other uses could cause
injuries and/or damages.
