background image

Burner Flame

Check

• Light burner;

rotate knob(s)
from HIGH to
LOW.  You
should see a
smaller flame in
LOW position than seen on HIGH.
Always check flame prior to each
use.  The air damper mounted on
the back of your burner helps to
control the amount of primary air
that mixes with the LP gas.  A blue
flame with little or no yellow flame
provides the best heat.  Adjust the
air damper by turning it clockwise
or counterclockwise until the

desired flame is achieved.

Turning LP Cooker Off

• Turn all knobs to OFF position.

Turn LP tank OFF by turning hand-
wheel clockwise to a full stop.

Hose Check

• Before each use, check to 

see if hoses are cut or worn.
Replace damaged hose assembly
before using appliance.  Use only 
valve/ hose / regulator specified by
manufacturer. See product sheet for
hose & regulator information.

Cleaning The Burner

NOTE: Spiders and small insects can
spin webs and build nests inside the
burner.  This especially occurs in late
summer and fall before frost when
spiders are most active.  These nests 

burner to create a free flow of air.

2. Turn regulator control valve to

OFF position.

3. Fully open LP bottle valve.
4. Light match and place it over

burner.  Slowly turn ON the
regulator control valve.  Do NOT
stand with head or arms over
cooker.

5. If ignition does not occur in 5

seconds, turn the burner control(s)
off, wait 5 minutes, and repeat the
lighting procedure.

Lighting with Rotary Ignitor:

Do not lean over LP cooker while
lighting.
1. Remove all appliances from the

burner to create a free flow of air.

2. Turn regulator control valve to

OFF position.

3. Fully open LP bottle valve.
4. Turn valve to medium position.

Allow gas to flow to burner.
Immediately turn rotary ignitor.
The ignitor should spark and light
the burner.

5. If ignition does not occur in 5

seconds, turn the burner control(s)
off, wait 5 minutes, and repeat the
lighting procedures.

If built-in ignitor will not light,
follow instructions for lighting with
a match.
Curing of paints and parts will
produce an odor only on first use.

If the flame is accidentally

extinguished, turn the appliance

valves OFF and WAIT 5 minutes

before attempting to ignite.

Air Damper

5. Hold regulator, insert nipple (B)

into LP tank valve.  Hand tighten
coupling nut, holding regulator in
a straight line (C) with LP tank
valve so as not to cross thread the
connection.

6. Turn the coupling nut clockwise to

tighten to a full solid stop.  The
regulator will seal on the back-
check feature in LP tank valve,
resulting in some resistance.  An
additional one-half to three
quarters turn is required to
complete connection.  Tighten by
hand only – do not use tools.

NOTE:  If you cannot complete
connection, disconnect regulator and
repeat steps 5 and 6.  

If you are still

unable to complete the connection, 

do not use this regulator!

• Do not insert any foreign objects

into the valve outlet.  You may
damage the valve and cause a leak.
Leaking propane may result in
explosion, fire, severe personal
injury, or death.

• Never attempt to attach this

appliance to the self-contained LP
gas system of a camper or trailer or
motor home.

(B) Nipple has to be
centered into the LP
tank valve

(C) Hold coupling
nut and regulator as
shown for proper
connection to LP
tank valve

Leak Testing Valves, Hoses and

Regulator

1. Turn all control knob(s) to OFF.

2. 

Be sure regulator is tightly
connected to LP tank.

3. Completely open LP tank valve by

turning hand wheel counter
clockwise.  If you hear a rushing
sound, turn gas off immediately.
There is a major leak at the
connection. Correct before
proceeding.

4. Brush 

soapy

solution onto
i n d i c a t e d
c o n n e c t i o n s
shown at right.

5. If 

"growing"

bubbles appear,
there is a leak.  Close LP tank
valve immediately and retighten
connections.  If leaks cannot be
stopped, do not try to repair.  Call
for replacement parts.  Order new
parts by giving the serial number,
model number and name of items
needed to the Service Center at 
1-435-752-3922.

6. Always close LP tank valve after

performing tank leak test by
turning hand wheel clockwise. 

Lighting Stove with Match:

Do not lean over LP cooker while
lighting.
1. Remove all appliances from the

WARNING

• Do not use appliance until leak

checked.

• If you cannot stop a gas leak,

immediately close LP tank valve
and call LP gas supplier or your
fire department!

Reviews: