8
(C) Hold coupling nut and
regulator as shown for proper
connection to LP tank valve
(B) Nipple has to be centered
into the LP tank valve
7. Turn the coupling nut clockwise to tighten to a full solid
stop. The regulator will seal on the back-check feature
in LP tank valve, resulting in some resistance. An
additional one-half to three quarters turn is required to
complete connection. Tighten by hand only – do not use
tools.
NOTE: If you cannot complete connection, disconnect
regulator and repeat steps 6 and 7. If you are still unable
to complete the connection, do not use this regulator!
• Do not insert any foreign objects into the valve outlet.
You may damage the valve and cause a leak. Leaking
propane may result in explosion, fire, severe personal
injury, or death.
• Never attempt to attach this appliance to the self-
contained LP gas system of a camper or trailer or motor
home.
WARNING
Appliance must be leak checked outdoors in well-
ventilated area, away from ignition sources such as gas
fired or electrical appliances. During leak test, keep
appliance away from open flames or sparks.
NOTE:
represents off.
Leak Testing
1. Turn all control knob(s) to OFF.
2. Be sure regulator is tightly connected to LP tank.
3. Slowly open LP tank valve by turning hand wheel counter
clockwise. If you hear a rushing sound, turn gas off
immediately. There is a major leak at the connection.
Correct the leak before proceeding.
4. Brush 50/50 soap and water solution onto indicated
connections shown.
5. If “growing” bubbles appear, there is a leak. Close LP
tank valve immediately and retighten connections. If
leaks cannot be stopped, do not try to repair. Call for
replacement parts. Order new parts by giving the serial
number, model number and name of items needed to the
Service Center at 1-435-752-3922.
6. Always close LP tank valve after performing tank leak
test by turning hand wheel clockwise.
WARNING
• Do not use appliance until leak checked.
• If you cannot stop a gas leak, immediately close
LP tank valve and call LP gas supplier or your fire
department!
Hose Check
• Before each use, check to see if hoses are cut or worn.
Replace damaged hose assembly before using appliance.
Use only valve/hose/regulator specified by manufacturer.
See product sheet for hose & regulator information.
Warning: Never operate the appliance without the grill
grease cup installed under the appliance. Never use the
griddle without the griddle grease cup installed. See
assembly instructions for proper assembly.
Lighting Instructions
Follow the instructions exactly.
1. Check that all burner control knobs and the cylinder
valve are turned to the “OFF” position.
2. Turn on the fuel supply by rotating the cylinder valve
knob counter-clockwise to full open.
3. DO NOT stand with head, body, or arms over the grill
when lighting.