1. POWER ON
Press any button on the unit or
Power Button
of the remote control to turn the
power on. The monitor is automatically opened. When REVERSE wire is connected
to the signal output (12V) of the reverse gear, the monitor is automatically opened
and the mode is set to RVC
2. POWER OFF
Press the
Power Button
on the unit more than 1 second or the remote controller again
to turn the power off. And the monitor is automatically closed. If the car key is pulled
out, the monitor will be closed automatically.
Press any button, the monitor will be opened.
Press
Open/Close Button
on the unit. The monitor will be closed or opened. If it is
not closed, hold left and right upper side of the monitor and make the monitor parallel
with the unit as the picture.
The tilt position can be adjusted in 8 steps by pressing
Tilt Up/Down Button
. Each
time you press
Tilt Up/Down Button
the monitor will swing one step backward or
forward.
If the monitor is not paralled to the front of the unit, the monitor
will not be closed.
9
60°
110°
Basic Operation
POWER ON / OFF
OPENING THE MONITOR
CLOSING THE MONITOR
ADJUSTING TILT POSITION