The move position can be adjusted in 4 steps by pressing more than 2 sec
Tilt Up /
Down Button
or
Tilt In / Out Button
of the remote controller.
If the monitor is not parallel to the front of the unit, the MOVE
function is not operated. You can hear fast beep tone, when you
operate the mechanism under abnormal conditions (Minimum,
Maximum, crooked angle of the front panel).
The monitor’s left / right position can be adjusted for easier viewing by hand as the
picture below.
Press
Mode Button
to select the desired mode. Each time you press this button, the
mode changes as follows.
If the REVERSE wire is connected to power output of the
reverse gear, the mode will be automatically changed to RVC
when the gear is positioned to REVERSE.
AV1 AV2 RVC
10
7
mm
7
mm
Basic Operation
ADJUSTING MOVE POSITION
ADJUSTING LEFT / RIGHT VIEWING POSITION
SELECTING MODE