Turbo 7 Log Splitter
Turbo7/0213
Page 11
Safety
Do not force the blade by pushing the log on the upper part (fig. 9, page 5) as this can cause the
blade to break or damage the body of the machine. Always set the log on the guides.
Never leave the machine unattended while it is running. If you leave the machine, even for a short
time, remove the power supply or any possible cause of accidental start-up.
The Log Splitter must never be used by an operator who is under the influence of alcohol, drugs,
medicines, or who is tired. A clear mind is essential for safety.
Never try to release a jammed log while the machine is running. The machine must be switched off
during this operation.
Never request the assistance of another person to help you remove a jammed log.
Do not use machines if natural gas, petrol fumes or other inflammable vapours are present.
Check that the electric circuit to which the machine will be connected is suitable.
Power,
voltage and frequency of the motor must be checked (verify the nameplate on the motor and the
data in this manual). The machine must be connected to a circuit with a regulation differential
switch upstream and, in compliance with the norms
(30 mA rated fault current)
, with a ground
connection.
Use cables with a section of 2.5mm
2
. Avoid use of free and inadequately insulated connections.
Connections must be made with protected material suitable for outdoor use.
Do not use cable
extensions longer than 5m. Cables that are too long or cables with inadequate section
may cause voltage drops and don’t allow the motor to develop all the power.
Always
check the cable extension for any damage before using it.
Never open the pushbutton box on the motor. Should this be necessary, contact a qualified
electrician.
Make sure that the machine and the cable never come in contact with water.
Treat the power cable with care. Do not attempt to move the machine by pulling the cable. do not
yank the cable to unplug it; keep the cable away from excessive heat, oil and sharp objects.
Never leave the machine unattended with the power supply “on”. After use, always switch the
machine off and disconnect it from the power supply, especially when any maintenance work is
required.
Do not use alcohol, petrol, or solvents to clean the machine. This could cause the safety information
applied to the machine itself to become illegible.
Summary of Contents for Turbo 7
