CamFive CFL-CMA1610T, User Manual, Page: 9 / 56

9
CONTROL PANEL
The operation panel includes the display area and keypad. Note that the backlight will go out when 60 seconds has
passed without any key.
Press any key to turn it on again. The keypad contains 16 keys. Refer to the description
below for the function of each key.
1. E-stop
is
mainly designed for emergency when required. The current work stops, and the laser head first
moves to the machine point origin and then back to the engraving origin set by the user. Pressing the E-stop
button during operation may greatly impact the device, so it is forbidden to use unless it is an emergency.
To terminate the present work, press “Start/Pause” to pause first and then
“ESC”. The system stops the
current work and returns to the wait mode. After releasing the key, the system will be initialized.
2. Press “Menu” to access the menu interface. In the File List interface, press it to access the File Copy
interface.
3. Pulse key is use to send a laser pulse during calibration.
4.
Press “ESC” to quit operation or return to the previous menu.
5.
Press “Enter” to confirm an operation or to enter the next menu.
6. Press “Speed” to enter the engraving speed setup interface. The speed can be set between 0% and 100%.
The key is only available when the system is in standby mode. The 100% speed corresponds to the terminal
speed in the machine parameters.
7. “Min Power” to access the minimum power setup interface. The power can be set between 0% and 100%.
The key is only available when the system is in standby mode.
8.
“Max Power” to access the maximum power setup interface. The power can be set between
0% and 100%.
The key is only available when the system is in standby mode,
9. Pressing “Repeat” enables the system to repeat work or perform engraving & cutting processing of a
specified file. The engraving data outputted from a PC are saved in the built-in memory of the engraving
machine. The system is able to finish engraving without a computer, i.e., to work offline. To engrave one
graph repeatedly, use the “Repeat” key. The key is available only when the system is in standby mode and
the engraving data have been saved in the machine.
10. “Start/Pause” enables the system to start engraving and cutting with the specified file. When the system is
working, press the key to have the system pause and press it again to resume the work. The key is available
when the system is in working, pause and standby mode.
11. Origin key is designed to define (change) the engraving origin. To change the engraving origin before
engraving, move the laser head to the start position for engraving with direction keys, and press the key to
confirm the current position of the laser head as the engraving origin. The key is only available when the
system is in standby mode.