7
Configure Menu
The Configure Flow Run 1 screen below
shows configuration settings for an
AGA-3 gas run. Required parameters will
vary, depending on the flow calculation
method selected (step 6).
For information on configuring a steam
flow run, see the ModWorX™ Pro User
Manual.
If a liquid turbine input will be used in
addition to a compensated gas run, click
on Turbine Input 1 for configuration
options.
5
Set the units of measure-
ment used for volume and rate.
7
Click “Change Plate” to
specify plate parameters.
9
Enter base conditions
specific to the location.
10
Click “Change Composition”
to specify the gas composition.
(Percentages must total 100%.)
8
Specify pipe parameters.
11
Click OK to save the new
selections to memory.
4
Set the calculation period.
1
Set the instrument date and
time.
2
Establish archive settings
• parameters to be logged
• contract hour
• interval period for saving logs
3
Configure flow run
parameters (as shown below).
6
Click “Change” to select the flow
calculation method and fluid property
calculation method to be used.
From the Configuration
menu (right), a user can access
every setting required to
perform the initial setup for
the Scanner 2000.