OPERATING AND USER MANUAL QUARTZ SERIES
46
Flat field calibration status
8.3.6.
The status of a pending calibration can be queried by issuing command:
Command format: FFSTA?
Return Message: x
Where x indicates the status according to the following table:
X
CALIBRATION STATUS
0
Done
1
Full dark field offset calibration pending
2
Incremental dark field offset calibration pending
3
Gain calibration pending
10
Load or save calibration pending
No calibration can be started if the calibration status is unequal 0.
Flat field calibration error result
8.3.7.
During the process of flat field calibration (FFCAL), storage or retrieval of flat field data (FFSC, FFLC)
the error status can be queried by command:
Command format: FFERR?
Return Message: x
Where x indicates the status according to the following table:
#
DEFINITION
0
No error
1
Starting a calibration action while a calibration is still pending
2
Non volatile storage CRC error during read of flat field data
100
Ratio of maximum over minimum video level more than 4x or minimum video in image below 5% of
full-scale during global gain calibration (FFCAL3 & FFP101;1). No calibration will be generated. If this
error occurs, use command FFMINMAX? to retrieve the detected video levels.
101
FFCAL3 started with auto exposure adjustment (FFP102;1), but acquisition mode of camera is not
continuous
102
Auto exposure adjustment failed, sensor exposure too low
103
Auto exposure adjustment failed, sensor exposure too high
104
Auto exposure adjustment failed, sensor exposure instable
110
FFCAL=3 not allowed in combination with FFSEL=0
500
Internal camera error (e.g. time out of internal process)
The error status will be cleared at the start of a flat field calibration or storage command.
Summary of Contents for Q-12A65
Page 1: ...Operating and user manual QUARTZ SERIES CAMERA LINK MODELS ...
Page 2: ...OPERATING AND USER MANUAL QUARTZ SERIES 2 ...
Page 5: ...OPERATING AND USER MANUAL QUARTZ SERIES 6 ...
Page 11: ...OPERATING AND USER MANUAL QUARTZ SERIES 12 ...
