6
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
2
POWER OUT
White Power Twist power output socket to supply power to additional Cameo spotlights (max. 6 A).
3
DMX IN
Male 5-pin XLR connector to connect a DMX control device (e.g., DMX console).
4
DMX OUT
Female 5-pin XLR connector to transmit the DMX control signal.
5
OLED DISPLAY
The OLED display shows the currently active operating mode (main display 1), the W-DMX status (main display 2) of the menu options in the
Options menu, and the numerical values or operating status for certain menu options. Briefly press ENTER and DOWN at the same time to
switch between the two main displays. You can access the main menu from main display 1. If there is no input within approx. 1 minute, the
display automatically switches to the main display. Please note the following information about the main display in DMX or W-DMX mode: As
soon as the control signal is interrupted, the symbols on the display will begin to flash. When the control signal is present again, the flashing
will stop. Starting from the main display, press UP on the control panel to rotate the display 180°.
6
TOUCH-SENSITIVE CONTROLS
MENU – you can access the options menu by pressing MENU. Pressing it again will return you to the main screen. If you press MENU with-
out having first pressed ENTER to confirm a value or status change, the previously confirmed value or status shall be restored.
ENTER – pressing ENTER takes you to the menu level, on which value changes can be made, and you can reach the submenu using ENTER.
Value or status adjustments can also by confirmed by pressing ENTER.
UP and DOWN – selects the individual menu options in the selection menu (DMX address, operating mode, etc.) and in the submenus.
Allows you to change the value of a menu option (e.g., DMX address) as desired.
Before changing device settings, check that the control unit is dry and clean in order to ensure that it is functioning properly.
7
FUSE
Fuse holder for 5 × 20 mm micro fuses. IMPORTANT NOTE: Only replace the fuse with a fuse of the same type and values. If a fuse trips
repeatedly, please contact an authorized service center.
8
SAFETY EYEBOLT
Safety eyebolt for securing the spotlight on crossbeam installations and for hanging the spotlight from a ceiling for permanent installations.
9
ANTENNA
Antenna for W-DMX wireless control
10
CONNECTING TERMINAL
The connecting terminal is used to supply permanent installations with power and signals. Please observe the safety instructions for hook-
ing up the terminal in the “HOOKING UP THE CONNECTING TERMINAL” section!
OPERATION
NOTES
• As soon as the spotlight is properly connected to the power supply, it can be used right away and the previously activated operating mode
will start.
• Briefly press MENU to go up one level in the lower levels of the menu structure. If necessary, press MENU repeatedly to access the main
display. If there is no input within approx. 30 seconds, the main screen 1 is automatically activated.
• Starting from the main display 1, briefly press the UP button to rotate the display 180°.
• Press and hold UP or DOWN to quickly change a value (e.g., DMX start address).
MAIN SCREEN 1 DMX MODE
The
DMX Address
and the currently configured DMX start address (e.g.,
001
) are shown on the display.
