8
After installation, the top of the cooking vessel support will be
located 15mm below the bench top surface.
The installer MUST test the operation of the appliance after
installation to ensure satisfactory operation.
Built-in Cut Out Dimensions
The cabinet must be mounted on a support structure, and the
material should be heat-resistant.
The cabinet built-in hole must be parallel and suitable for
installation.
The underside of this stove can become very hot during use.
When this stove is installed in a location where the underside is
easily accessible, the installation must include a barrier 30mm
below the lowest point of the stove to prevent accidental touch
access.
The data label is not usually visible after installation, so this
hotplate has been supplied with a duplicate data label. The
installer must attach the duplicate data label to an adjacent surface,
or the inside surface of a nearby cupboard, where it can be easily
referenced by the consumer after installation.
Refer to the cut-out dimensions below for the respective gas hob
model.
